Skip to main navigation Skip to content Skip to footer

Products Effective Against Coronavirus

Approved Products

Per the EPA's Emerging Pathogen Policy, the products in this table can be used against COVID-19 when used as directed on hard, nonporous surfaces.

  • Clorox® Disinfecting Wipes1

    • EPA Reg. No. 5813-79
    • Remove excess dirt.
    • Wipe down surface. Use enough wipes for treated surface to remain visibly wet for 4 minutes.
    • Let surface dry.
    View Product >

  • Clorox® Clean-Up® Cleaner + Bleach1 (Spray)

    • EPA Reg. No. 5813-21
    • Remove excess dirt.
    • Spray product 4-6 inches from surface until thoroughly wet.
    • Let stand for 30 seconds.
    • Rinse or wipe clean.
    View Product >

  • Clorox® Disinfecting Bleach2

    • EPA Reg. No. 5813-111
    • Pre-wash surface.
    • Mop or wipe with solution of ½ cup bleach to 1 gallon of water.
    • Allow solution to contact surface for at least 5 minutes.
    • Rinse well with clean water and let surface air dry.

  • Clorox® Bleach Foamer (Original Scent)

    • EPA Reg. No. 5813-24
    • Turn nozzle to “ON.”
    • Tilt bottle at a downward angle while spraying.
    • Wait at least 5 minutes.
    • Wipe with sponge or cloth.
    View Product >

  • Clorox® Bleach Foamer (Lemon Scent)

    • EPA Reg. No. 5813-21
    • Turn nozzle to “ON.”
    • Tilt bottle at a downward angle while spraying.
    • Wait at least 30 seconds.
    • Wipe with sponge or cloth.

  • Clorox® Clean-Up® Cleaner + Bleach1 (Use Dilution)

    • EPA Reg. No. 5813-21
    • For heavily soiled surfaces, pre-clean surface before disinfecting.
    • Mix ½ cup of this product per gallon of water.
    • Wet surface completely with cloth or sponge.
    • Let stand 5 minutes.
    • Rinse or wipe clean.
    • Allow to air dry.
    View Product >

  • Clorox® Disinfecting Bathroom Cleaner

    • EPA Reg. No. 5813-40
    • Turn nozzle to “ON.”
    • Tilt bottle at a downward angle while spraying.
    • Wait 10 minutes.
    • Wipe with sponge or cloth.
    View Product >

  • Clorox® Scentiva® Bathroom Disinfecting Foamer

    • EPA Reg. No. 5813-40
    • Spray 6-8 inches from surface.
    • Allow foam to sit on surfaces for 10 minutes.
    • Wipe and rinse.
    View Product >

  • Clorox® Disinfecting Wipes1 To-Go Pack

    • EPA Reg. No. 5813-79
    • Remove excess dirt.
    • Wipe down surface.
    • Let surface dry (needs to maintain surface contact for 4 minutes for disinfection).
    View Product >
View More View Less

Other Products

EPA suggests that a product with a claim against a human coronavirus can be used if a product with the emerging viral pathogen claim is not available. Clorox® has the following products with a claim against another type of human coronavirus that is different from COVID-19. The contact time listed may be shorter than for the products listed above but this is because coronaviruses are enveloped viruses and easier to kill than the large or small non-enveloped pathogens required for the emerging viral pathogen guidance.

  • Clorox® Scentiva® Disinfecting Multi-Surface Cleaner

    • EPA Reg. No. 5813-73
    • Spray 6–8 inches from soiled surface.
    • Let sit for 10 minutes.
    • Wipe clean with a dry paper towel or lint-free cloth.
    • Repeat for heavily soiled areas.
    View Product >

  • Formula 409® Multi-Surface Cleaner

    • EPA Reg. No. 5813-73
    • Spray on soiled surface.
    • Let sit for 10 minutes.
    • Wipe clean with a dry paper towel or lint-free cloth.
    View Product >

  • Clorox® Disinfecting ToiletWand® Refills

    • EPA Reg. No. 5813-93
    • Empty toilet bowl before cleaning.
    • Open pouch of disposable cleaning heads.
    • Push handle straight down onto cleaning head until it clicks into place.
    • Dip cleaning head in toilet bowl water for 1–2 seconds.
    • Scrub entire toilet bowl above water line.
    • Let stand for 10 minutes.
    • Hold wand over trash and press side button forward to release.
    • Flush toilet to rinse.
    View Product >
View More View Less

Next Read About